Shop with confidence! This product has been fully inspected to avoid any buyer surprises. Read our in-depth product listing below.

Your purchase will NOT include: This product is pre-owned and may not include the same accessories as a new, unused unit. - other accessories not shown or listed here.
Prior to testing this autoclave, the major components were inspected and tested and found to be functioning normally. Then the Reservoir Tank was cleaned and flushed and a new Safety Valve, Condenser Coil, Air Jet Valve and Reservoir Cap were installed. Cleaned the sterilizing chamber and installed a new Door Gasket and Door Bellows Assembly. Also installed a new Power Switch. Cleaned the sterilizing trays and rack. To test this autoclave, it was first connected to a 120 volt power source, distilled water was added, it was then properly levelled as per it's chamber size requirement and then testing began. This sterilizer was run through cycles of 270 F for 10 minutes and 250 for 30 minutes several times. To verify that this autoclave is achieving it's maximum required sterilizing temperature during a cycle, it was temperature tested with the use of a Max Register Thermometer, and found to exceed 270 F during a sterilization cycle.